It’s Christmas. The house is full, the oven is going, and someone notices the radiators are cold. The thermostat shows the house slowly getting cooler, and the boiler in the basement is quiet. A boiler not working on Christmas feels like the worst possible timing. Most of the time, though, you can handle it calmly: rule out danger, check a few simple things, keep everyone warm, and get a technician on the way.
This post walks you through what to do first, the safe checks a homeowner can make (thermostat, power switch, pressure gauge, low-water cutoff and pilot), the signs that mean you should stop and call, and how to keep the house and the pipes warm until help arrives.
Boiler Not Working on Christmas? Rule Out Danger First
Before you touch anything, take a few seconds to make sure this is a heat problem and not a safety problem.
- If you smell gas (a rotten egg smell), do not touch light switches, the thermostat or the boiler. Get everyone out of the house, then call 911 or your gas utility from outside.
- If a carbon monoxide alarm is sounding, get everyone out, pets included, and call 911. Do not go back in until responders say it is safe. Carbon monoxide has no smell, so trust the alarm. Our post on carbon monoxide and your boiler or gas water heater explains the warning signs.
- If water is pouring from the boiler or from the relief valve (the valve on the side or top of the boiler with a pipe pointing toward the floor), turn the boiler off at its power switch and call for help.
- If you hear loud banging, see scorch marks or soot, or smell something burning, turn the boiler off and call.
If none of that is happening, you have time. A cold house is uncomfortable, but it rarely becomes dangerous in the first hour or two. That gives you a chance to do some basic checks.
The checks below are safe for most homeowners. They don’t involve opening the boiler, and they don’t involve any gas piping. If they don’t bring the heat back, that is the point to bring in a technician for gas and steam boiler repair.
Safe Checks You Can Make Before Calling
It helps to know what kind of system you have. A hot water system pushes heated water through baseboard or radiators, and the boiler usually has a round gauge showing pressure and temperature. A steam system sends steam up to radiators, which often hiss as they heat, and the boiler has a small glass tube on the side showing the water level. Some checks apply to one type and not the other.
1. Check the Thermostat
This sounds too simple, but it solves more no heat calls than you would expect, especially with guests in the house.
- Make sure it is set to Heat, not Off or Cool.
- Turn the setting a few degrees above the current room temperature.
- If the screen is blank or dim, replace the batteries.
- If you have a programmable or smart thermostat, check that a schedule or away mode isn’t holding the temperature down.
Wait several minutes. Boilers don’t respond instantly.
2. Check the Boiler Power Switch and Breaker
Most boilers have an emergency shutoff switch. It often looks like a light switch, sometimes with a red cover plate, and it is usually at the top of the basement stairs or near the boiler. During the holidays, people go up and down to the basement for extra chairs and decorations, and it’s easy for someone to flip it by mistake.
- Make sure the switch is on.
- Check your electrical panel for a tripped breaker labeled boiler, burner or heat.
- If a breaker is tripped, reset it once. If it trips again, leave it off and call. A breaker that keeps tripping is telling you something is wrong.
3. Read the Pressure Gauge (Hot Water Systems)
The gauge on a hot water boiler shows the water pressure in the system. Many home systems sit somewhere around 12 to 15 psi when cold and run a little higher when hot, but systems differ, so check your boiler’s label or manual if you have it.
- If the needle is near zero, the system may be low on water. The boiler may shut itself down to protect itself. This is a call for a technician, because something let the water out, and that leak needs to be found.
- If the needle is high, close to the number stamped on the relief valve, turn the boiler off and call. High pressure usually points to a problem with the fill valve or the expansion tank (a small tank that gives heated water room to expand).
Don’t try to drain or add water to a hot system yourself.
4. Check the Water Level and Low-Water Cutoff (Steam Systems)
Steam boilers have a safety device called a low-water cutoff. It shuts off the burner if the water in the boiler drops too low, which keeps the boiler from running dry and damaging itself. A low water level is one of the most common reasons a steam boiler goes quiet.
Look at the sight glass, the small glass tube on the side of the boiler.
- If you can see water partway up the glass, the level is probably fine. The problem may be the cutoff itself, which can get clogged with sediment, or something else entirely.
- If the glass is empty or nearly empty, turn the boiler off and let it cool. Do not add water to a hot boiler. Cold water hitting a hot, dry boiler can crack it.
- Some low-water cutoffs have a reset button. If yours does and the water level is fine, you can press it once.
If a technician has shown you how to add water to your steam boiler, and the boiler is fully cool, you can follow those exact steps. Otherwise, leave it for the technician.
5. Look at the Pilot or the Reset Button
What you check here depends on your fuel.
Gas boilers. Older gas boilers have a standing pilot, a small flame that stays lit all the time. Newer boilers light electronically and have no pilot to see. If you have a pilot and it’s out, there is usually a lighting label on the boiler. Only follow it if there is no gas smell at all, you have done it before, and you follow the label exactly. If it won’t light or won’t stay lit, stop. That usually points to a worn part, such as the thermocouple (a small sensor that tells the gas valve the pilot is lit), and that needs a technician. It’s completely fine to skip this step and wait for help.
Oil boilers. Plenty of Long Island homes still heat with oil. Oil burners have a reset button, usually red, on the burner itself. Press it once. If the burner starts and keeps running, good. If it doesn’t, do not keep pressing it. Each press can send more oil into the combustion chamber, and that oil can ignite all at once when the burner finally lights.
6. Check Your Fuel Supply
If you heat with oil, look at the gauge on top of the tank. A cold stretch before the holidays can burn through oil faster than usual, and an empty tank is an easy thing to miss. If you heat with gas, check whether your stove burners light. If they don’t, the issue may be with the gas supply, and you should call your gas utility.
Signs It’s Time to Stop and Call
These checks are meant to catch the simple problems. Stop and call a professional if:
- You smell gas at any point (leave first, then call 911 or the gas utility).
- Your carbon monoxide alarm goes off.
- The breaker trips again after one reset.
- The oil burner won’t run after one press of the reset button.
- The pressure gauge reads very low or very high.
- The steam boiler’s sight glass is empty.
- The pilot won’t light or won’t stay lit.
- You see water leaking from the boiler, the pipes or the relief valve.
- The boiler runs but the radiators or baseboard stay cold, which can mean a failed circulator pump or zone valve.
- You simply aren’t comfortable going further. That is a good enough reason.
How to Keep the House Warm Until Help Arrives
While you wait, focus on two things: keeping people warm and keeping the pipes from freezing.
Keep Everyone Comfortable
- Gather people in one or two rooms and close the doors to the rest of the house.
- Close curtains and blinds at night. During the day, open the ones that get sun.
- Roll a towel along the bottom of drafty doors.
- Hand out sweaters, blankets and warm drinks. Watch older relatives and babies closely, since they get cold faster.
- The kitchen will be warm from cooking. It’s fine to let people gather there, as long as the oven is only used for cooking.
Use Space Heaters Carefully
An electric space heater can make a big difference in one room. Use it safely:
- Plug it directly into a wall outlet, not an extension cord or power strip.
- Keep it a few feet away from curtains, bedding, furniture, the Christmas tree and piles of wrapping paper.
- Keep kids and pets away from it.
- Turn it off when you leave the room or go to sleep.
Never Use These for Heat
- Never use a gas oven or stovetop to heat the house.
- Never run a generator, grill, camp stove or kerosene heater indoors or in an attached garage.
These can produce carbon monoxide quickly, and that is far more dangerous than a cold night.
Protect Your Pipes
In a cold snap, a house without heat can freeze pipes, especially along outside walls, in crawl spaces and in garages.
- Open cabinet doors under sinks on outside walls so warmer room air can reach the pipes.
- On a very cold night, let a faucet on an outside wall drip slowly.
- If a faucet produces only a trickle or nothing, a pipe may already be frozen. Don’t use a torch or open flame on it. Tell the technician when you call.
Our guide on how to winterize plumbing on Long Island has more on keeping pipes safe through the winter.
What a Technician Does When They Arrive
A good technician starts with safety. They check for gas leaks and carbon monoxide, then work through the system step by step: the controls, the ignition, the burner, the safety devices like the low-water cutoff and relief valve, and the parts that move heat through the house, like circulator pumps and zone valves.
Many no heat problems come down to one worn or failed part. Sometimes it’s a sensor, a control, a pump or an ignition component. Once the cause is found, you should hear what’s wrong and what it will take to fix it before any work starts. At Minutemen, you get an upfront estimate, so you know the price before we start.
On a holiday, a specific part may not always be available right away. If that happens, the technician should make the system safe, explain your options and help you plan to stay warm until the repair is finished. If your boiler is old and has needed repeated repairs, you may also want to read about boiler repair vs. replacement before you decide anything.
Who Can Fix a Boiler on Christmas Day
Not every company answers the phone on December 25. Minutemen Sewer & Drain provides 24/7, 365-day emergency service, holidays included, for homes and businesses across Nassau County, Suffolk County and Queens. We aim to arrive within about 30 minutes on emergency calls, depending on location, and usually within the hour. Our technicians are insured and licensed to handle emergency gas repairs.
Whether you’re in East Norwich or elsewhere on the North Shore, you can find more about our plumbing services in East Norwich, including heating and emergency work.
When you call, it helps to have a few details ready: whether you heat with gas or oil, whether the system is steam or hot water, what the pressure gauge or sight glass shows, and anything you already tried. That helps the technician come prepared.
Preventing a Holiday Heating Breakdown Next Year
No boiler is immune to failure, but a little attention goes a long way.
- Have the boiler serviced before the heating season. A technician can clean it, test the safety controls and catch worn parts before the coldest weeks.
- Test your carbon monoxide and smoke alarms and replace batteries as needed.
- If you heat with oil, stay on top of deliveries, especially before a holiday when you may be busy or away.
- Learn your system. Know where the emergency switch is, what type of boiler you have, and where the pressure gauge or sight glass normally sits.
- Keep the area around the boiler clear. Holiday boxes and decorations often get stacked in the basement. Keep them well away from the boiler.
- Pay attention to small changes. New noises, rooms that don’t heat evenly or a boiler that cycles on and off more than usual are worth a call before they turn into a no heat night.
When to Call a Plumber About Your Boiler
Call right away if you smell gas (after leaving and calling 911 or the gas utility), if a carbon monoxide alarm sounds, or if you see leaking water, scorch marks or a dry steam boiler. Call as well if the simple checks above didn’t bring the heat back, or if you aren’t comfortable going further. There’s no prize for fixing it yourself, and a boiler involves fuel, fire and pressure. If you want to know more about how we approach heating problems, our boiler repair page covers the service in detail.
Minutemen answers emergencies 24/7, including Christmas, at (516) 222-9110 in Nassau, (631) 789-3150 in Suffolk and (718) 465-6544 in Queens, or through the contact page.
Frequently Asked Questions
Can I get a boiler repaired on Christmas Day on Long Island?
Yes, though not every company works the holiday. Minutemen Sewer & Drain offers 24/7, 365-day emergency service, including holidays, across Nassau, Suffolk and Queens. We aim to arrive within about 30 minutes on emergency calls, depending on location, and usually within the hour.
Is it safe to relight my boiler’s pilot light myself?
Only if there is no gas smell at all, you have done it before, and you follow the lighting label on the boiler exactly. If it won’t light or won’t stay lit, stop and call a technician. If you smell gas, leave the house and call 911 or your gas utility from outside. It’s always fine to skip this step and wait for help.
How many times should I press the reset button on my oil burner?
Once. If the burner doesn’t start and keep running after one press, leave it alone and call. Pressing it repeatedly can send extra oil into the combustion chamber, which can be dangerous when the burner finally lights.
Can I use my oven to heat the house while the boiler is down?
No. A gas oven or stovetop used for heat can produce carbon monoxide, and so can generators, grills and camp stoves used indoors. Gather people in a few closed-off rooms, use blankets and layers, and if you use an electric space heater, plug it directly into a wall outlet and keep it well away from anything that can burn.
How do I keep my pipes from freezing while the heat is off?
Open the cabinet doors under sinks on outside walls so room air can reach the pipes, and on very cold nights let a faucet on an outside wall drip slowly. If a faucet gives only a trickle or nothing, a pipe may be frozen. Don’t use a torch or open flame on it; mention it to the technician when you call.